User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
6 - 14 TROUBLESHOOTING
White lines down the page
■ You may clear the problem by wiping the scanner window with a soft cloth.
See Cleaning in Chapter 5.
■ The toner cartridge may be damaged. Put in a new toner cartridge. See
Replacing the toner cartridge in Chapter 5.
Page skewed
■ Make sure the paper or other print media is loaded properly in the paper tray
and that the guides are not too tight or too loose against the paper stack.
■ Set the paper guides correctly. See Printing on plain paper from the paper tray
in Chapter 1.
■ If you are using the manual feed tray (or the multi-purpose tray), see Printing
on plain paper from the manual feed tray (For HL-5030 and HL-5040) in
Chapter 1 or Printing on plain paper from the multi-purpose tray (MP tray) (For
HL-5050 and HL-5070N) in Chapter 1.
■ The paper tray may be too full. See Printing on plain paper from the paper tray
in Chapter 1.
■ Check the paper type and quality. See What kind of paper can I use? in
Chapter 1.
Curl or wave
■ Check the paper type and quality. High temperatures and high humidity will
cause paper to curl. See What kind of paper can I use? in Chapter 1.
■ If you don’t use the printer very often, the paper may have been in the paper
tray too long. Turn over the stack of paper in the paper tray. Also, try fanning
the paper stack and then rotating the paper 180° in the paper tray.
■ Try printing using the straight-through output path. See Printing on plain paper
from the manual feed tray (For HL-5030 and HL-5040) in Chapter 1 or Printing
on envelopes from the MP tray (For HL-5050 and HL-5070N) in Chapter 1.
Wrinkles or creases
■ Make sure that paper is loaded properly. See Printing on plain paper from the
paper tray in Chapter 1.
■ Check the paper type and quality. See What kind of paper can I use? in
Chapter 1.
■ Try printing using the straight-through output path. See Printing on plain paper
from the manual feed tray (For HL-5030 and HL-5040) in Chapter 1 or Printing
on envelopes from the MP tray (For HL-5050 and HL-5070N) in Chapter 1.
■ Turn over the stack of paper in the tray or try rotating the paper 180° in the
input tray.
Examples of poor print
quality
Recommendation
ABCDEFGH
abcdefghijk
ABCD
abcde
01234
ABCDEFGH
abcdefghijk
ABCD
abcde
01234
B DEFGH
abc efghijk
ACD
bcde
134