User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
5 - 7 ROUTINE MAINTENANCE
7
Clean the primary corona wire inside the drum unit by gently sliding the blue tab from right to left
and left to right several times. Return the tab to the home position (▲) before you put the drum unit
back in the printer. If you do not, printed pages may have a vertical stripe.
Figure 5-12
8
Put the drum unit assembly back in the printer. Close the front cover of the printer.
Figure 5-13