User`s guide
Table Of Contents
- Definitions of warnings, cautions, and notes
- To use the printer safely
- Brother Numbers (USA and Canada)
- Frequently asked questions (FAQs)
- Important information: Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220 to 240 volt model only)
- International ENERGY STAR® Compliance Statement
- Laser Safety (100 to 120 volt model only)
- FDA Regulations (100 to 120 volt model only)
- IEC 60825 specification (220 to 240 volt model only)
- IMPORTANT - For Your Safety
- Trademarks
- Table of Contents
- About this printer
- Driver and software
- Control panel
- Options
- Routine maintenance
- Troubleshooting
- Appendix
- INDEX
5 - 3 ROUTINE MAINTENANCE
Toner Empty message
If the LED shows the message below, the printer has run out of toner or the toner is not evenly distributed
inside the cartridge.
Figure 5-2
Replacing the toner cartridge
1
Press the cover release button and then open the front cover of the printer.
Figure 5-3
To make sure you get high quality print, make sure you use quality toner cartridges. When you want
to buy toner cartridges, call the dealer you bought the printer from.
We recommend that you clean the printer when you replace the toner cartridge. See Cleaning in
this chapter.
Toner
Drum
Paper
Status