Service manual

CHAPTER 7 SOFTWARE SERVICE SUPPORT

7-16

10) Input 9 digit serial number in the PIT3 control window, then press ENTER. PIT3 will be

started, “RUNNING” message appears in the PIT3 status window accordingly.

11) “SER:VVVVVVVVVVVVVVVVVV” message appears in the PIT3 control window, and

“PASS” message appears in ERR CODE section. “READY” message appears in the PIT3

status window. (READY is displayed in about 3 seconds.)

The error generated step appears in the PIT3 control window, error code appears in ERR

CODE section, “ERROR” message appears in the PIT3 status window. To release the

error, Input “check”, then press ENTER.

Please carry out (9) again at the time of error generating. If the error message still

appears, please judge that there is something wrong with PCB.

12) Turn the printer power switch OFF, then disconnect the USB cable.

13) In case of performing the rewriting work to other printers, repeat from the step 2. To finish

working, Input “quit” in the PIT3 control window, then press ENTER key.

14) Turn off the printer. Serial number and the other settings will be effective when the printer

is turned on.

MODEL Input Message

HL-5030 /CS5030 CS5030 (SCRPT:Y.YY)

HL-5040 /CS5040 CS5040 (SCRPT:Y.YY)

HL-5050 /CS5050 CS5050 (SCRPT:Y.YY)

HL-5070N /CS5070N CS5070N (SCRPT:Y.YY)

Y,YY expresses a version of script

Code Country HL-5030 HL-5040 HL-5050 HL-5070N

.00101 USA X O O O

.00102 Canada X O O O

.00103 German O O O O

.00104 UK O O O O

.00106 Australia X O O O

.00107 Norway X X X O

.00110 Switzerland O O O O

.00112 Finland X X O O

.00113 Denmark O O O O

.00115 Spain O O O O

.00116 Italy O O O O

.00117 Israel X O O O

.00124 South Africa O O O O