Service manual

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY

4-36

(23) Disconnect the connector for the eject sensor harness from the thermistor relay PCB

ASSY.

(24) Release the eject sensor harness from the three hooks.

(25) Remove the bind B M3x10 Taptite screw, and then remove the eject sensor PCB ASSY.

(26) Remove the bind B M3x10 Taptite screw, and then remove the thermistor relay PCB

ASSY.

Fig. 4-63

(27) Remove the paper eject actuator and eject actuator spring.

Fig. 4-64

Taptite, bind B M3x10

FU frame lower

Thermistor relay PCB ASSY

Eject sensor PCB ASSY

FU frame lower

Eject actuator spring

Paper eject actuator

(hook)

Hooks

Hook

Eject sensor harness