Service manual

I-10
8.9 Paper Mode
8 paper modes are available for this printer. Modes are switched over under the
instruction from the controller.
<Classification of paper mode>
(1) Plain paper: Japanese plain paper such as FX-P, L, R, J/JD, and plain paper
such as XC-4200 20lb, 24ibs RX-80, 90.
(2) Label-L mode: It is mainly selected to run on Japanese labels (V860 etc.).
(3) Label-H mode: It is mainly selected to run on labels (3R4469 etc.).
(4) Thick paper-L mode: it is selected to run on the papers whose thickness is 106-
162gsm.
(5) Thick paper-H mode: It is selected to run on the papers whose thickness is 163-
216gsm.
(6) OHP mode: It is selected to run on OHPs (JE-001 etc).
(7) Envelope mode: It is selected to run on envelopes.
(8) Postcard mode: It is selected to run on postcards.
Relation between the resolution, process speed, print mode and paper mode is shown in
the table below.
Resolution/Process speed
Paper mode
600dpi 1200dpi
Print mode Simplex Duplex Simplex Duplex
Standard mode Full speed Full speed -- --
Fine mode -- -- Half
speed
Half
speed
Plain
paper
(1)
Thick
paper
(4)-(5)
High gloss mode Half
speed
Half
speed
-- --
Fine mode -- -- Half
speed
Half
speed
Special paper
(2)-(3)
(6)-(8)
High gloss mode Half
speed
Half
speed
-- --