Service manual

I-4
6. ELECTRICAL PROPERTIES
6.1 Power Source
Two types of power source as follows are available for this printer, which are selected
according to the specifications.
* 100V/120V printer: Voltage: 100-127VAC ±10% (90 to 140V), frequency: 50/60Hz ±
3Hz
* 220/240V printer: Voltage: 220-240VAC ±10% (198 to 264V), frequency: 50/60Hz ±
3Hz
6.2 Power Consumption
Power consumption in each operation mode at rated voltage input
Operation mode Average (Wh/h) *1 Max. power consumption
Printing mode
(Running mode)
600W
900W
(Fuser is on)
READY mode
(Ready mode)
180W
900W
(Fuser is on)
ENAGISTAR mode *2 --
45W
(Controller is included)
*1 At running mode : wattage per hour at printing continuously.
At ready mode : wattage per hour at the temperature of fuser ready.
*2 Fuser is in stop status.
7. MECHANICAL PROPERTIES
7.1 Dimensions / Mass of Printer
Width: 439mm ± 1%
Depth: 590mm ± 1% (with no cassette installed), 638mm ± 1% (with cassette installed)
Height: 445mm ± 1%
Mass
(No cassette installed + (No CRU): 26.8 kg ± 1%
(No cassette installed + (CRU): 32.5 kg ± 1%
(Cassette installed + (No CRU): 29.2 kg ± 1%
(Cassette installed + CRU): 34.9kg ± 1%
Fig.1-5