Service manual

V-52
4.8.4 NVM Information Print
Function: Printing MCU NVM information saved in ESS
Operation procedure:
1. Enter the Diag. (C/E) mode.
2. Select [IOT Diag] with the
and buttons and press the Form Feed/Set button.
3. Select [NVM Settings] with
and buttons and press the Form Feed/Set button.
4. Advance to [NVM Print Info] with the
and buttons and press the Form
Feed/Set button.
4.8.5 NVM Information Save
Function: Saving information from the MCU NVM evacuate list into ESS NVM
Operation procedure:
1. Enter the Diag. (C/E) mode.
2. Select [IOT Diag] with the
and buttons and press the Form Feed/Set button.
3. Select [NVM Settings] with
and buttons and press the Form Feed/Set button.
4. Advance to [NVM Save] with the
and buttons and press the Feed/Set button
to display the Confirm Initialize screen.
Press the Job Cancel/Back button to cancel.
5. When the Form Feed/Set button is pressed, the NVM information is saved and the
following screen is displayed:
4.8.6 NVM Information Load
Function: Loading ESS-saved MCU NVM information into MCU
Operation procedure:
1. Enter the Diag. (C/E) mode.
2. Select [IOT Diag] with the
and buttons and press the Form Feed/Set button.
3. Select [NVM Settings] with
and buttons and press the Form Feed/Set button.
4. Advance to [NVM Load] with the
and buttons and press the Form Feed/Set
button to display the Confirm Initialize screen.
Press the Job Cancel/Back button to cancel.
5. When the Form Feed/Set button is pressed, the NVM information is loaded and the
following screen is displayed:
NVM Save MCU -> ESS
OK?
NVM Save MCU -> ESS
Saved
NVM Load ESS -> MCU
OK?
NVM Load ESS -> MCU
Loaded