Service manual

V-51

4.8.3 NVM Edit Read/Write

Refer to Section 7. NVM LIST.

Function: Reading or writing NVM

Operation procedure:

1. Enter the Diag. (C/E) mode.

2. Select [IOT Diag] with the

and buttons and press the Form Feed/Set button.

3. Select [NVM Settings] with

and buttons and press the Form Feed/Set button.

4. Advance to

[NVM Edit] with

and buttons and press the Form Feed/Set

button.

5. Select a necessary item for the address section (Ad) with the

and buttons.

The NWM data is read and two to four items are displayed from the input address.

Press the

or button to moves the cursor to the left or right.

Press the

or button to change value on cursor.

6. Change the numeric value at the desired data section with the

buttons.

If the data section is changed, the * mark disappears to indicate that the current

NVM value has changed.

7. Press the Form Feed/Set button to write the NVM value.

Edit NVM

Ad0001=00000000*

Edit NVM

Ad0001=c6d0d6d0

Cursor