Service manual

V-45
Menu
No.
Part/signal name Test method
Reference
BSD
DI-11
TRAY1 NO PAPER SENSOR Block and unblock the sensor
with an actuator.
2.6.1
DI-12
TRAY2 NO PAPER SENSOR Block and unblock the sensor
with an actuator.
2.6.2A
2.6.2B
DI-13
TRAY3 NO PAPER SENSOR Block and unblock the sensor
with an actuator.
2.6.3
DI-14 KIT SENSOR OHP Plain paper is checked. 2.7.6
DI-15
TRAY1 LOW PAPER SENSOR Increase and decrease paper on
Tray1 for sensor detection and
no detection.
2.6.1
DI-16
TRAY2 LOW PAPER SENSOR Increase and decrease paper on
Tray2 for sensor detection and
no detection.
2.6.2A
2.6.2B
DI-17
TRAY3 LOW PAPER SENSOR Increase and decrease paper on
Tray3 for sensor detection and
no detection.
2.6.3
DI-18
TRAY1 SIZE SWITCH
(DISPLAY)
Set the side guide and end
guide of tray1 to the paper size.
Check the sensors signal.
The value (from 00 to 07) is
displayed that corresponded
with the size of paper. Refer to
the BSD.
2.6.1
DI-19
TRAY1 SIZE SWITCH
(SW1)
Set the side guide and end
guide of tray1 to the paper size.
Check the sensors signal.
When the SW1 is switched on,
displays L (low). Refer to the
BSD.
2.6.1
DI-1a
TRAY1 SIZE SWITCH
(SW2)
Set the side guide and end
guide of tray1 to the paper size.
Check the sensors signal.
When the SW2 is switched on,
displays L (low). Refer to the
BSD.
2.6.1
DI-1b
TRAY1 SIZE SWITCH
(SW3)
Set the side guide and end
guide of tray1 to the paper size.
Check the sensors signal.
When the SW3 is switched on,
displays L (low). Refer to the
BSD.
2.6.1
DI-20
TRAY2 SIZE SWITCH
(DISPLAY)
Set the side guide and end
guide of tray2 to the paper size.
Check the sensors signal.
The value (from 00 to 07) is
displayed that corresponded
with the size of paper. Refer to
the BSD.
2.6.2A
2.6.2B
DI-21
TRAY2 SIZE SWITCH
(SW1)
Set the side guide and end
guide of tray2 to the paper size.
Check the sensors signal.
When the SW1 is switched on,
displays L (low). Refer to the
BSD.
7.2B
2.6.2A
2.6.2B