Service manual

V-9
LCD Display < Name of Fail>
Contents of Trouble
Action Reference
BSD
Clean Up
CTD Sensor
<IOT CTD Sensor Dustiness>
ADC sensor ASSY signal level below the specified value.
Clean ADC sensor ASSY.
See CTD sensor dustiness
FIP
2.8.7
2.8.8
Close
Front Cover
<IOT Front Cover Open>
Font cover is open.
Close the front cover.
See front cover FIP
2.1.1
2.1.2
Empty
Exit Tray
<IOT Standard Stacker Full>
Exit tray is full.
Remove output paper stack.
See full stack FIP
2.9.4
2.9.6
(During job waiting or auto paper
feeding)
Push in a Tray
(When a tray is specified)
Push in Tray N
<Tray Detached>
*All existing trays are open during job waiting or auto paper
feeding. (All Tray Detached)
*The specified tray is open when a tray is specified. (Specified
Tray Detached)
Push in the tray.
N indicates the tray no.
2.6.1
2.6.2A
2.6.2B
2.6.3
2.6.4
(When paper is being fed from a
tray)
Check Paper in Tray N
(When paper is being fed from
manual tray)
Check Paper in MP Tray
<IOT Paper Size Mismatch>
Paper Size Mismatch detected.
Open/close the tray or reload
the manual feed
paper.
N indicates the tray no.
2.6.1
2.6.2A
2.6.2B
2.6.3
2.6.4
2.7.2
2.7.7
(When auto select is specified)
Load XX in a Tray
(When a tray is specified)
Load XX in Tray X
(When manual feed is specified)
Load XX in Manual Tray
(During job waiting)
One step tray configuration:
No Paper in Tray N
N steps tray configuration:
No Paper in All Trays
<No Suitable Paper>
*All existing trays are open during job waiting or auto paper
feeding. (All tray empty)
*All existing trays are different in size when auto paper feeding is
selected. (All tray size mismatch)
*The specified tray is empty when a paper tray is specified
(Specified tray empty)
*Paper loaded in the specified tray is different from the size
specified in the job when a paper tray is specified.
(Specified tray size mismatch)
Load the specified paper in
the tray.
N indicates the tray no.
XX indicates paper size.
2.6.1
2.6.2A
2.6.2B
2.6.3
2.6.4
2.7.2
2.7.7