Service manual

- IV-69 -
2.6.4 Feeder ASSY unit
1) Remove the connector connecting the printer and feeder ASSY unit from the left
side of the printer.
2) Remove the 2 connectors connecting the printer and feeder ASSY unit from the
right side of the printer.
3) Remove 8 screws securing the feeder ASSY unit to the printer.
4) Remove 4 long screws securing the feeder ASSY unit to the printer.
CAUTION
The top unit of the printer should be raised up by more than two people.
Note:
When removing the top unit of the printer from the feeder ASSY unit, be careful not to
drop or damage the upper part of the printer.
5) Raise the printer and separate it from the feeder ASSY unit, taking care not to
damage the cables.
Note:
Take care not to trap the harness on the feeder ASSY unit, when replacing the printer
top unit on the feeder ASSY unit.
Fig.4-122
Feeder ASSY unit
Screw, M3x10
Screw, M3x10
Screw, M3x10
Screw, M3x10
Screw, M3x10
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x85
Washer-lock EXT TEETH
Screw, M3x10