Service manual

- IV-46 -

3) Remove the connector (D) on the PWBA EEPROM STD on the left side of the

printer.

4) Remove the connector (E) on the S-HVPS on the left side of the printer.

5) From the printer, release the fan harness from the clamps.

6) Remove the connector (F) from the connector block.

7) Release the 2 hooks securing the gear slide to the shaft on the left side of the

printer.

8) Remove the gear slide from the printer.

9) Remove the rack V from the printer.

Fig.4-82

10) Remove 7 screws securing the holder toner cartridge ASSY unit to the printer.

11) Remove the holder toner cartridge ASSY unit from the printer.

Fig.4-83

S-HVPS

PWBA EEPROM

Rack V

Gear slide

Holder toner cartridge ASSY unit

Screw, M3x6

“E”

“D”

“F”