Service manual

- IV-37 -

2.3.25 Chute ASSY REGI

1) Release the 2 hooks securing the housing ASSY ELEC to the printer and remove

the housing ASSY ELEC upward.

Fig.4-65

2) Disconnect the 2 connectors of the chute ASSY REGI from the printer.

3) Remove 4 screws securing the chute ASSY REGI to the printer.

4) Lift the left end of the chute ASSY REGI and pull out the chute ASSY REGI

leftwards from the printer.

Note:

Take care not to damage the plastic film when refitting the chute ASSY REGI.

Fig.4-66

Housing ASSY ELEC

Chute ASSY REGI

Screw, M3x10