Service manual

- IV-34 -

7) Remove 1 screw securing the wire ASSY FSR earth on the right side of the printer.

8) Release the harness of the fuser drive ASSY from the clamp on the drive ASSY

main.

9) Shift the harness of the harness ASSY FSR3 (FSR32,FSR4) from the hook of the

housing on the right side of the printer.

10) Release the latch at A from the printer, and pull out the chute ASSY IN frontward

and remove.

Fig.4-59

2.3.20 Holder ASSY CTD

1) Release the 4 hooks securing the holder ASSY CTD to the chute ASSY IN.

2) Raise the holder ASSY CTD slightly from the chute ASSY IN and pull out the

connector.

3) Remove the holder ASSY CTD from the chute ASSY IN together with the spring

CTD.

4) Remove the spring CTD from holder ASSY CTD.

Fig.4-60

Holder ASSY CTD

Chute ASSY IN

Spring CTD

Chute ASSY IN