Service manual

- IV-18 -
2.2.14 Link: L
1) Remove the top of spring link: L from the projection on the left side of the printer.
2) Slide the link: L rearward and align the shaft of the printer and hole of the link: L.
3) Remove the link: L from the printer together with the spring link: L.
4) Remove the spring link: L from the link: L.
Fig.4-34
2.2.15 Link: R
1) Remove the top of spring link: R from the projection on the right side of the printer.
2) Slide the link: R rearward from the printer and align the shaft of the printer and the
hole of the link: R.
3) Remove the link: R from the printer together with the spring link: R.
4) Remove the spring link: R from the link: R.
Fig.4-35
Spring link: L
Link: L
Spring link: R
Link: R