Setup guide
Table Of Contents
- Quick Setup Guide
- Symbols used in this guide
- Table of Contents
- Safety Precautions
- To Use the Printer Safely
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Important
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220-240 volt model only)
- EC Declaration of Conformity
- International Energy Star® Compliance Statement
- Laser Safety (110 to 120 volt Model Only)
- FDA Regulations (110 to 120 volt Model Only)
- Caution
- IEC 60825-1 specification (220 to 240 volt model only)
- Caution
- For Finland and Sweden
- Varoitus!
- Varning
- Internal laser radiation
- IMPORTANT - For Your Safety
- Maschinenlärminformations- Verordnung 3. GPSGV (For Germany only)
- Disconnect device
- Caution for LAN connection
- IT power system (For Norway only)
- Wiring information (for UK) Important
- Warning - This printer must be earthed.
- Wi-Fi Alliance certification
- Getting Started
- STEP 1 - Setting Up the Machine
- STEP 2 - Installing the Printer Driver
- Windows®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Macintosh®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Windows®
- For Network Users
- Consumables
- Repacking Information
Installing the Printer Driver
42
STEP 2
Macintosh
®
Macintosh
®
Wireless
Network
14 Check the box after you confirm that you have
completed the wireless settings, and then click
Next.
Installing the printer driver
Improper Setup
• DO NOT try to cancel any of the screens during
this installation.
• If your wireless settings fail, an error message
will appear during the installation of the printer
driver and the installation will be terminated. If
you encounter this failure, please go back to
step 4 and setup the wireless connection
again.
15 The driver installation starts.
Follow the on-screen instructions. Then, restart
your Macintosh
®
.
For Mac OS
®
X 10.2.4 to 10.2.8 users:
Go to step 18.
For Mac OS
®
X 10.3 or greater users:
Go to step 16.
16 The Brother software will search for the Brother
printer. During this time the following screen
will appear.
Note
If more than one printer is available, the following
list appears. Choose the printer you wish to
connect, and then click OK.
• If there is more than one of the same printer
model connected on your network, the
Ethernet address (MAC address) will be
displayed after the model name.
• You can find your printer’s Ethernet address
(MAC address) by printing out the Printer
Settings Page. See Print the Printer Settings
Page on page 46.
17 When this screen appears, click OK.
For Mac OS
®
X 10.3 or greater users:
Setup is now complete.
18 When this screen appears, click Add.
19 Make the following selection.