Setup guide
Table Of Contents
- Quick Setup Guide
- Symbols used in this guide
- Table of Contents
- Safety Precautions
- To Use the Printer Safely
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Important
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220-240 volt model only)
- EC Declaration of Conformity
- International Energy Star® Compliance Statement
- Laser Safety (110 to 120 volt Model Only)
- FDA Regulations (110 to 120 volt Model Only)
- Caution
- IEC 60825-1 specification (220 to 240 volt model only)
- Caution
- For Finland and Sweden
- Varoitus!
- Varning
- Internal laser radiation
- IMPORTANT - For Your Safety
- Maschinenlärminformations- Verordnung 3. GPSGV (For Germany only)
- Disconnect device
- Caution for LAN connection
- IT power system (For Norway only)
- Wiring information (for UK) Important
- Warning - This printer must be earthed.
- Wi-Fi Alliance certification
- Getting Started
- STEP 1 - Setting Up the Machine
- STEP 2 - Installing the Printer Driver
- Windows®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Macintosh®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Windows®
- For Network Users
- Consumables
- Repacking Information
Installing the Printer Driver
40
STEP 2
Macintosh
®
Macintosh
®
Wireless
Network
Configuration using the automatic wireless (one-push) method
If your wireless access point supports either
SecureEasySetup™, Wi-Fi Protected Setup™
(PBC
1
) or AOSS™, you can configure the machine
easily without a computer. By pushing a button on the
wireless LAN router / access point and the machine,
you can setup the wireless network and security
settings. See the user’s guide for your wireless LAN
router / access point for instructions on how to access
one-push mode.
1
Push Button Configuration
Note
Routers or access points that support
SecureEasySetup™, Wi-Fi Protected Setup™ or
AOSS™ have the symbols shown below.
Configure the wireless settings
1 Make sure the printer power switch is on.
2 Turn on your Macintosh
®
. Put the supplied CD-
ROM into your CD-ROM drive.
3 Double-click the HL2100 icon on your desktop.
Double-click the Start Here icon. Follow the
on-screen instructions.
4 Click Install Printer Driver on the menu
screen.
5 Click Wireless Network users.
6 Choose Wireless Setup and Driver Install
(Recommended), and then click Next.