Setup guide
Table Of Contents
- Quick Setup Guide
- Symbols used in this guide
- Table of Contents
- Safety Precautions
- To Use the Printer Safely
- Regulations
- Federal Communications Commission (FCC) Declaration of Conformity (For USA)
- Important
- Industry Canada Compliance Statement (For Canada)
- Radio interference (220-240 volt model only)
- EC Declaration of Conformity
- International Energy Star® Compliance Statement
- Laser Safety (110 to 120 volt Model Only)
- FDA Regulations (110 to 120 volt Model Only)
- Caution
- IEC 60825-1 specification (220 to 240 volt model only)
- Caution
- For Finland and Sweden
- Varoitus!
- Varning
- Internal laser radiation
- IMPORTANT - For Your Safety
- Maschinenlärminformations- Verordnung 3. GPSGV (For Germany only)
- Disconnect device
- Caution for LAN connection
- IT power system (For Norway only)
- Wiring information (for UK) Important
- Warning - This printer must be earthed.
- Wi-Fi Alliance certification
- Getting Started
- STEP 1 - Setting Up the Machine
- STEP 2 - Installing the Printer Driver
- Windows®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Macintosh®
- For USB interface cable users
- For wired network interface cable users
- For wireless network users
- Windows®
- For Network Users
- Consumables
- Repacking Information
Setting Up the Machine
12
3 Printing a test page
Improper Setup
DO NOT connect the interface cable yet.
1 Make sure that the printer power switch is off.
Connect the AC power cord to the printer.
2 Plug the AC power cord into an AC power
outlet. Turn on the printer power switch.
3 Unfold support flap 1.
4 After the printer has finished warming up, the
Ready LED / Go button (1) stops blinking and
stays blue.
5 Press the Go button. The printer prints a test
page. Check that the test page has printed
correctly.
Note
This function will not be available after the first
print job you send from your computer.
1