Specifications

Revision C 16/01/96
Chapter 3 "PJL" - 22
Variables for HL-660
1) General PJL Environment Variables
The PJL environment variables which are not printer language-specific are listed in the following table.
When using these valuables, do not use the LPARM.
Variables Description Sample Value Range
COPIES Number of uncollated copies for each page of
the job.
1 to 200
MANUALFEED Feed the paper from manual feed slot or not. ON or OFF
ECONOMODE Turn the economy mode (toner saving mode)
ON or OFF.
ON or OFF
ECONOLEVEL Select the toner saving level from 1 (high) to
3 (low).
1 to 3
PERSONALITY Set the emulation mode. AUTO, PCL, IBM,
EPSON, POSTSCRIPT
XOFFSET Set the X offset ( horizontal offset ) value. -500 to 500 dots
YOFFSET Set the Y offset ( vertical offset ) value. -500 to 500 dots
AUTOCONT Auto Continue Mode ON or OFF
TIMEOUTEMU Set the time-out value for automatic
emulation switching.
1 to 99 seconds
PRIORITY Set the priority between EPSON or IBM for
automatic emulation switching.
EPSON or IBM
AUTOFF Set the auto FF setting to ON or OFF. ON or OFF
TIMEOUTFF Set the timeout value for auto FF. 1 to 99 seconds
TIMEOUT Set the time-out value for Automatic interface
switching
1 to 99 seconds
CDCCHIGH Set the high-speed transfer mode of
Centronics interface to ON or OFF.
ON or OFF
DTRCTRL Select when DTR becomes low.
0 = the printer is turned off-line by SEL
switch, input buffer is full, or printer error
occurs.
1 = the printer is turned off-line by SEL switch
or printer error occurs.
2 = the printer is turned off-line by SEL
switch.
0 to 2
AUTOSLEEP Set the automatic sleep mode ON or OFF. ON or OFF
TIMEOUTSLEEP Set the timeout value for automatic sleep
mode.
1 to 00 minutes.
IBMCHARE1 BETA or ESSZET
REPRINT Set the reprint function ON or OFF. ON or OFF
DEMOPRINT Enable the Demo page printing or not. ON or OFF
PAGEPROTECT Configuration of the Page protection mode.
This mode reserves a block of printer memory
to avoid 31 PRINT OVERUN error.
AUTO, OFF, LETTER,
LEGAL, A4
RESOLUTION Printer resolution setting. If the printer can
not print a large file at 600 dpi because of
insufficient memory, the printer decreases the
resolution to 300 dpi automatically
300, 600
LANG Select the language for RPC program. ENGLISH, FRENCH,
GERMAN, DUTCH or
NORWEGIAN
KEEP PCL If set to ON, the printer keeps the permanent
font and permanent macro of PCL when the
emulation is changed to the other mode.
ON or OFF
DOUBLESTRIKE Enable the bold printing in IBM or EPSON
mode
ON or OFF