Instruction Manual

200747_1TB 10
Fig 1
Assembly – Decorative Log Retainer
Using the 2 off M5 C/Sunk Bolts provided, locate the decorative trim behind the stove
opening as shown and secure in position.
Assembly - Fitting TTB sensor
Connection to gas valve
Pilot Assembly TTB Connections
With the burner installed, thread the 2 x TTB wires from the
pilot / thermocouple to the rear of the stove. Attach the two
spade connections to the TTB which is fitted to the bracket
shown in Fig 1. Attach the bracket to rear panel of the stove by
inserting the keyhole cut-outs over the existing screw heads
and drop down to final position. Tighten screws if required.
Ensure the white fibre is between the stove and bracket.