Operating instructions

MS07-11 Issue 4b 14
Controls Explained
Fire needs air to burn therefore the stove is fitted with an air control that allows you to
regulate the amount of combustion air therefore controlling the burn rate within the
appliance.
Secondary Air Intake
The secondary air intake is located on the front of the stove below the door, it is in the form
of a slider. Having the slider pushed to the right indicates that the air intake is in the
closed/minimum position and to the left indicates it is in the fully open/maximum position.
In smoke controlled areas you should fit the smoke exempt washer behind the control, this
will prevent the control from fully closing.
Air entering through this control is directed through the holes in the air firebrick and also
down the inside of the glass creating the AIRWASH system – see below. The air wash
system reduces the amount soot and particle's making contact with the glass. This control
is used at initial lighting and to control the burn rate of your wood.
The sections LIGHTING THE STOVE & BURNING WOOD gives a step by step guide on
how to operate this control.
Air wash System
Air wash is a system where secondary air is drawn into the stove (by combustion) through
the secondary air control and is deflected down the back face of the glass, thus preventing
the smoke coming into contact with the glass. It does not mean that you will never have to
clean the glass, but substantially lengthens the periods between having to do so. The air-
wash system works best when burning dry wood. Wet wood will produce more deposits
on the glass. Also, deposits will form on the back of the glass when the stove is operated
on low heat for extended periods (where fuel is only just smouldering).
Ash Pan
The ash pan can be accessed by lifting out the grate. The tool can be used for this task. It
is recommended that this is done when the stove is cold and not alight.