Specifications


Introduction
May we take this opportunity to thank you for choosing one of our stoves.
These appliances are designed to burn hardwood logs. It is essential that your wood has
been seasoned to ensure that it is sufficiently dry for burning. You can determine the
moisture content of your logs by using a digital moisture meter, your logs need to be below
20% moisture content (Preferably in the centre of the log) before they are considered dry
enough for burning. Never burn wood that contains paint, glue or any other chemicals
See the section “Recommended Fuels” & “Lighting the Stove” for further details. After
reading this document, if there is anything you are unsure about, please contact your
dealer or our Technical Support Department.
These instructions cover the basic principles to ensure the satisfactory installation of the
stove, although detail may need slight modification to suit particular local site conditions. In
all cases the installation must comply with current Building Regulations, Local Authority
By-laws and other specifications or regulations as they affect the installation of the stove.
It should be noted that the Building Regulations requirements may be met by adopting the
relevant recommendations given in British Standards BS 8303, BS 6461 and BS 7566 as
an alternative means to achieve an equivalent level of performance to that obtained
following the guidance given in Approved Document J.
Please note that it is a requirement under the Broseley Fires warranty system that
the installation of the stove is carried out by a Competent Person registered with a
Government approved Competent Persons Scheme. HETAS Ltd operate such a
Scheme and a listing of their Registered Competent Persons can be found on their
website at www.hetas.co.uk
. Your installer is responsible for designing and
implementing any aspect of the installation, he/she may sub-contract certain areas
but all work must be done to your installers design and specification.
3DFNLQJ/LVW
1x Cast Iron/Steel Stove 1x Log retainer set
2x Rear Firebricks 1x Spigot & Fixings
4x Bottom Firebricks 1x Spigot Ring
1x Front Baffle 1x Ash Tool & Glove Set
1x Grate Support Set 1x Smoke Exempt Washer
2x Side Firebricks 1x Instruction Booklet
4x Grates
2x Ashpans
All seperate parts will be inside the main stove body.
MS10-11C Issue 2 3