User's Manual

caRe anD MaInTenance (conTInUeD)

CLEANING THE LENS

1. Power off the Scanner and remove

your device.

2. Hold the handle of the LENS CLEANER.

3. Insert the LENS CLEANER, with the

fabric side facing UP, all the way into

the EXIT SLOT of the Scanner.

4. Slide the LENS CLEANER back and

forth, all the way to either end of the

EXIT SLOT, to clean the lens. Repeat a

few times.

chaRGInG YoUR DevIce

1. Power off the Scanner before docking your device.

2. With the Scanner powered off, but still connected to a power source,

dock your device to the 30-PIN CONNECTOR.

3. Your device will indicate the status of its charge.

Note: If your device is not charging, make sure the Scanner is

powered off, remove your device and then re-dock.