User Guide

Page: 2 /2
MRWH
Rolling Stand With 12 Pivot Hangers
Assembly Instructions
1) Slide lower frame assembly (part 11)
into both side frame assemblies
(part 5). Insert two set screws (part 6)
into lower frame assembly but do not
tighten.
2) Attach spreader
assembly (part 4)
into side frame
assembly using
two M4X60 bolts
(part 2) and
washers (part 3).
3) Slide upper frame assembly (part 7)
into the two side frame assemblies.
4) Insert two set screws (part 6) into
upper frame assembly but do not
tighten.
5) Install locking casters (part 12) into
lower frame assembly and non-
locking casters (part 1) into side
frame assemblies.
6) Guide 12 hangers (part 10) with
12 springs (part 9) at top of
hangers into the top of the upper
frame assembly as shown in
diagram and then insert lower
part of hanger into bottom hole
of upper frame assembly.
7) Set the upper
frame assembly
and lower frame
assembly at the
desired height
and depth and
secure set screws
with Allen key (part 13)