Installation Manual

DLWC
Drop Lift Wall Rack
Assembly Instructions
Installation recommended on wall studs or solid back wall surface.
1)
Determine width of wall brackets based upon the width of the print clamp jaws that are being using. Add
approximately 1/4＂~1/2＂ to the width of the jaws. Detail distance refer to table above. For example the
spacing between the inner frames of the rack brackets would be 24-1/4＂ when using 24＂ clamps.
2)
Locate wall studs and attach rack brackets (part 1) using eight (part 5) screws. If you cannot locate wall studs
we suggest you attach the rack to a solid wall surface. If you cannot locate the studs or are unable to attach to
a solid wall surface, we suggest that you have the rack installed by a professional using hollow wall anchors.
3)
Attach knob assemblies (part 4) to wall brackets using screws (part 2) and washers (part 3) to keep the clamps
from sliding off the brackets.
Clamp Size Distance
18＂ 18-1/2＂
47cm
24＂ 24-1/4＂
61.6cm
30＂ 30-1/4＂
76.5cm
36＂ 36-1/4＂
91.8cm
42＂ 42-1/4＂
107cm
Page: 2 / 2