Installation Manual

DLWC

Drop Lift Wall Rack

Assembly Instructions

PARTS LIST

Description Qty Part Description Qty

Wall

bracket

Washer 2

Knob

assembly

M3X5

screw

#10X1＂

screw

Tools required for assembly: Phillips screwdriver

Page: 1 / 2

PAGE 1
DLWC Drop Lift Wall Rack Assembly Instructions PARTS LIST Qty Part Description Description 1 2 Wall bracket M3X5 screw Qty 3 Washer 2 4 Knob assembly 2 5 #10X1＂ screw 8 2 2 Tools required for assembly: Phillips screwdriver Page: 1 / 2
PAGE 2
DLWC Drop Lift Wall Rack Assembly Instructions Installation recommended on wall studs or solid back wall surface. Clamp Size 18＂ 24＂ 30＂ 36＂ 42＂ Distance 18-1/2＂ 24-1/4＂ 30-1/4＂ 36-1/4＂ 42-1/4＂ 47cm 61.6cm 76.5cm 91.8cm 107cm Determine width of wall brackets based upon the width of the print clamp jaws that are being using. Add approximately 1/4＂~1/2＂ to the width of the jaws. Detail distance refer to table above.