Specifications

Installation 8200 Compressor
Connecting the Compressor to the Cold HeadInstallation, Operation, and Service Instruc-
8040353 Brooks Automation
4-10 Revision 108
6. Make the following electrical connections.
a. Connect the cold head power cable to the rear panel of the compressor
and the other end to the electrical power connector on the high-vacuum
pump cold head.
b. Connect the compressor input power cable to the power source.
c. Turn on compressor.
d. Your system is now ready for operation.
Figure 4-5: Typical 8200 Compressor Installation
High Voltage
High voltage electric shock could cause severe injury
or loss of life.
Before you make any electrical connections, turn off
the compressor with the ON/OFF power switch on the
front of the compressor.
User’s
Vacuum
Chamber
On-Board Power Cable
Helium Return Line
Helium Supply Line
On-Board
Cryopump
Air Pressure (60-80 psi)
Nitrogen (40-80 psi)
Roughing Pump