Specifications

Installation 8200 Compressor
Preparing the Compressor Input-Power Cable Installation, Operation, and Service In-
8040353 Brooks Automation
4-4 Revision 108
Figure 4-1: Electrical Terminal Enclosure with Cover in Place
Figure 4-2: Assembly of Conductors to Terminal Block
Cooling Water Requirements (Water-Cooled Compressors Only)
If flexible water hose connections are used, install the barbed fittings supplied with
the compressor on the input and output connections:
1. Apply a light coating of standard plumbing thread sealant on the barbed fitting
threads.
Cover Screws
Power Cable
Ground Screw
X
Y
Z
(not used for single phase)