User guide

Brooks
®
Model 5850E
2-2
Installation and Operation Manual
X-TMF-5850E-MFC-eng
Part Number: 541B102AAG
September, 2009
Section 2 Installation
2-3 Return Shipment
Prior to returning any Brooks equipment to the factory, contact the factory -
for a Return Materials Authorization Number (RMA#). This can be obtained
at Brooks Instrument, Product Service Department, 407 West Vine Street,
Hatfield, PA 19440-0903, or call toll free 1-888-554-FLOW (3569).
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554 FLOW (3569)
Tel [phone]
Fax [phone]
E-mail: [e-mail]
www.BrooksInstrument.com
Brooks Instrument Brooks Instrument
Neonstraat 3 1-4-4 Kitasuna Koto-Ku
6718 WX Ede, Netherlands Tokyo, 136-0073 Japan
P.O. Box 428 Tel [phone]
6710 BK Ede, Netherlands Fax [phone]
Tel [phone] Email: [e-mail]
Fax [phone]
E-mail: [e-mail]
Also, completion of Form RPR003-1, Brooks Instrument Decontamination
Statement, as well as, a Material Safety Data Sheet (MSDS) for the fluid(s)
used in the meter, is required before any Brooks Personnel can begin
processing the equipment. Copies of the form can be obtained at one of
the locations above.
2-4 Gas Connections
Standard inlet and outlet connections supplied on the Model 5850E are
1/4" compression fittings for flow rates up to 10 slpm, and 3/8"
compression fittings for higher flow rates.
Optional VCO
TM
and VCR
TM
connections are available upon request. Prior
to installation, make certain all piping is clean and free of obstructions.
Install the piping in such a manner that permits easy removal if the
instrument is to be removed for cleaning or test bench troubleshooting.
2-5 Installation (Refer to Figs. 2-1 through 2-4)