User guide

Brooks
®
Model 5850E
2-1
Section 2 Installation
Installation and Operation Manual
X-TMF-5850E-MFC-eng
Part Number: 541B102AAG
September, 2009
2-1 Receipt of Equipment
When the equipment is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should immediately be notified regarding his
liability. A report should be submitted to the Product Service Department,
Brooks Instrument, 407 West Vine Street, Hatfield, Pennsylvania 19440.
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554 FLOW (3569)
Tel [phone]
Fax [phone]
E-mail: [e-mail]
www.BrooksInstrument.com
Brooks Instrument Brooks Instrument
Neonstraat 3 1-4-4 Kitasuna Koto-Ku
6718 WX Ede, Netherlands Tokyo, 136-0073 Japan
P.O. Box 428 Tel [phone]
6710 BK Ede, Netherlands Fax [phone]
Tel [phone] Email: [e-mail]
Fax [phone]
E-mail: [e-mail]
Remove the envelope containing the packing list. Outside of your clean
area, carefully remove the equipment from the packing case. Make sure
spare parts are not discarded with the packing material. Inspect for
damaged or missing parts.
2-2 Recommended Storage Practice
If intermediate or long-term storage is required for equipment, as supplied
by Brooks Instrument, it is recommended that said equipment be stored in
accordance with the following:
a. Within the original shipping container.
b. Store in a sheltered area, with the following conditions.
1. Ambient temperature 21°C (70°F) nominal, 32°C (90°F) maximum
and 7°C (45°F) minimum.
2. Relative humidity 45% nominal, 60% maximum and 25% minimum.
Upon removal from storage, a visual inspection should be conducted
to verify the condition of the equipment is "as received". If the
equipment has been in storage for an excess of ten (10) months or
in conditions in excess of those recommended, all pressure bound-
ary seals should be replaced and the device subjected to a pneu-
matic pressure test in accordance with applicable vessel codes.