User's Manual

Product Manual - RFID Reader UF70 Certum 131
Chapter 7
Operation
Parameter 04
(0x04)
MsgRepeat Delay Time
If a confirmation is not sent by the host, the device waits this time span before it
sends the message to the host again. The number of repetitions is defined in
parameter 6 (MsgMaxRepeat).
10 .. 250 [0.1 s]
Default: 0x32 (5 s)
Parameter 06
(0x06)
MsgMaxRepeat
If a confirmation is not sent by the host, the device repeats the message
according to the set value. Only then is an error message sent.
0 – 31
Default: 0x03
Parameter 07
(0x07)
First byte of the serial number (read only)
Represents the first byte of the serial number
 Device label.
This value is write protected!
Parameter 08
(0x08)
Second byte of the serial number (read only)
Represents the second byte of the serial number
 Device label.
This value is write protected!
Parameter 11
(0x0B)
Reader ID
This parameter defines the address of the device in the ASC-I1 protocol.
0 .. E
Default: 0x00
Parameter 12
(0x0C)
Acknowledgment Error Message
This parameter defines whether an error message must be confirmed or not.
0 – No confirmation expected
1 – a confirmation is expected
Default: 0x01