Installation Guide
Table Of Contents
- Installation Guide RFID Reader UF70 Certum
- 1 Identification
- 2 Safety Instructions
- 3 Product Specifications
- 4 Installation
- 5 Service and Troubleshooting
- 6 Dismantling and Disposal
- Index
Chapter 4
Installation
Installation Guide - RFID Reader UF70 Certum 26
4.8 External input and output (optional)
The following I/O versions are possible:
A digital input and output can be connected to each antenna port.
A 3 wire sensor or dry contact is possible as the input.
The output can operate a LED without a series resistor or directly switch 5 V DC.
4.9 Commissioning
4.9.1 Required operating conditions
To operate the reader, the following requirements must be met:
4.9.2 Parameters of the serial interface
Baudrate 57,600
Data bits 8
Stop bit 1
Parity No
An antenna must be connected correctly to the reader.
Connect the power supply and switch on the device (if a POE is not used).
The transponder must be located within the individual reading/writing
range of the antenna (for testing)!