User's Manual

RS232-Transponder Reader
(SECS1-Protocol), Release 0.3 Draft Page 59 of 91
2000-09-29
ID: ID000093
Initiator: bit6 – bit7
The initiator represents the number of the sensor which has caused the generation
of a message
0 Sensor 0
1 Sensor 1 (not realized at present)
3 cannot be assigned
Where used: S3F5, S3F7, S3F12, S3F13, S3F67
RAC Format: B[1]
Reset acknowledge code.
0: reset to be done
1: reset could not be done
Where used: S2F20
RIC Format: B[1]
Reset code.
1: Power up reset
2: Software reset
Where used: S2F19
SHEAD Format: B[10]
Stored SECS Message Block Header. Only the last message is stored which still
has to be confirmed by the Host!
Where used: S9F9