User's Manual

Software Reticle Read – Write Station – Stand Alone
Technical Reports, Release 1.1
Page 6 of 15
3 Hardware
3.1 Bar Code Reader
The barcode works with an ASCII protocol which uses the following settings,
COM settings: 38.400,N,8,1 (baud rate, parity, data bits, stop bits).
The bar code reader is configured as follows:
1.Set all defaults:
2. Fujitsu RS-232C
3. Baud rate 38.400
Note: If the BCR is not configured you have to read these labels in the right order.
3.2 Reticle Read / Write Station
The tag reader includes an RF module which is working on the frequency of
134.2 kHz. To display the data, the device has a dot character display module
with four lines and 40 signs per line. Additional the unit includes a membrane
keyboard with four buttons. The equipment is designed to handle any SEMI-E111
compliant carrier.