User's Manual

Software Reticle Read – Write Station – Stand Alone
Technical Reports, Release 1.1
Page 3 of 15
1 Hardware Description
At the back side of the Reticle Read/Write Station is one RS232 Sub-D male
connector labeled with Barcode Reader. The barcode reader P302FZY has to be
connected there. The power supply for this unit has to be connected to the female
connector at the back.
Connect the external power supply (24V) to the connector which is labeled with
power supply, and the reader starts working. The RF Tag reader needs about 3
seconds for initialization. The antenna is justified and the display will be initiated.
After this the reader shows the current software version and it is in operation
mode.
Important Note
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.