User's Manual

OPERATION 5
57
Transponder Reader LF60 Gen2 (SECS1-Protocol), Release 0.2
Parameter 28: Not defined!
Parameter 29: transponder load duration (read-mode)
The time required to load a transponder during a read process.
The default value (50ms) should not be changed!
00 .. 255 ms
Default: (50) 50ms
Parameter 30 – 33: Not defined!
Parameter 34: sensor type for presence sensor
Type of sensor signal to start an automatic read.
0 Automatic read starts if sensor is covered
1 Automatic read starts if sensor is not covered
Default: (0) sensor is covered
Parameter 35: special features
After a hardware reset the reader offers an automatic read if the
presence sensor is covered.
bit 0: Auto read starts if sensor is covered
(0..enabled/1..disabled)
bit 1: Without function
bit 2: Different load duration between read and write mode
(0..disabled/1..enabled) (see parameter 29 and 40)
Default: (0000 0001)