User's Manual

3 PRODUCT DESCRIPTION
18
Transponder Reader LF60 Gen2 (SECS1-Protocol), Release 0.2
3.3 Description
Power supply
Connector for the power supply.
Power LED
If the device is connected to a power supply, the LED is illuminated
green and the reader is ready for use.
Status LED
The status LED shows different operation modes.
DIP switches
The DIP switches can be used for tuning the antenna and for test mode.
Test LED’s
The two test LED’s shows the success or failure of a test read or write.
RS232 interface
The data are passed down serially to the RS232 interfaces (9 contact
Sub-D female plug). Baud rates of 300 Bd up to 115.2 kBd are
possible.
External input
A sensor (such as an optical sensor) can be connected to the external
input.
External output
The external output, usually a LED, shows the status of the device
(software-dependent).
Fuse
TR5 housing, 500 mA T (low breaking).