User's Manual
Table Of Contents
- Product Manual RFID Reader LF40C THR
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating personnel
- 7.2 Normal operating mode
- 7.3 Setup mode
- 7.3.1 Parameter
- Parameter 0 (0x00)
- Parameter 6 (0x06)
- Parameter 32 (0x20)
- Parameter 33 (0x21)
- Parameter 34 (0x22)
- Parameter 35 (0x23)
- Parameter 39 (0x27)
- Parameter 80 (0x50)
- Parameter 81 (0x51)
- Parameter 82 (0x52)
- Parameter 83 (0x53)
- Parameter 85 (0x55)
- Parameter 86 (0x56)
- Parameter 97 (0x61)
- Parameter 98 (0x62)
- Parameter 99 (0x63)
- 7.3.1 Parameter
- 7.4 Status diagram as overview
- 7.5 Flow chart
- 7.6 ASCII values for setup
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
- Index
Product Manual - RFID Reader LF40C THR 43
Chapter 8
Service and Troubleshooting
8 Service and Troubleshooting
This chapter gives you an overview of the following topics:
■ General remarks
■ Qualified troubleshooting personnel
■ Safety instructions
■ Reader does not respond
■ Software releases
■ Customer service
8.1 General remarks
Follow the instructions specified in the safety chapter.
Follow the general safety instructions in the chapter
Safety Instructions.
The RFID reader and its components must be serviced by the manufacturer
only!
If errors occur, follow the instructions in this section. Do not carry out any
error-eliminating measures other than the ones described in this section!
If you are uncertain about errors and their handling, contact the
manufacturer; see
Customer service. Have the serial number of the
transponder reader ready as shown on the label (see
Device label) when
contacting the manufacturer!