User's Manual
Table Of Contents
- Product Manual RFID Reader LF40C THR
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating personnel
- 7.2 Normal operating mode
- 7.3 Setup mode
- 7.3.1 Parameter
- Parameter 0 (0x00)
- Parameter 6 (0x06)
- Parameter 32 (0x20)
- Parameter 33 (0x21)
- Parameter 34 (0x22)
- Parameter 35 (0x23)
- Parameter 39 (0x27)
- Parameter 80 (0x50)
- Parameter 81 (0x51)
- Parameter 82 (0x52)
- Parameter 83 (0x53)
- Parameter 85 (0x55)
- Parameter 86 (0x56)
- Parameter 97 (0x61)
- Parameter 98 (0x62)
- Parameter 99 (0x63)
- 7.3.1 Parameter
- 7.4 Status diagram as overview
- 7.5 Flow chart
- 7.6 ASCII values for setup
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
- Index
Product Manual - RFID Reader LF40C THR 29
Chapter 6
Installation
6.2 Qualified installation personnel
6.3 Unpacking
The device and the accessories are packed under clean-room conditions. In order
to maintain this condition, the device must also be unpacked in clean-room
conditions.
Disposing of the
packaging material
CAUTION
The installation is to be carried out by specially trained personnel only. If you
are uncertain about their qualification, contact the manufacturer.
CAUTION
Operating the device without special training can result in damage to the reader
and/or connected devices.
The packaging material consists of cardboard and foil. Dispose of these
materials separately, and observing the legal regulations of your country.