User's Manual
Table Of Contents
- Product Manual RFID Reader LF40C THR
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating personnel
- 7.2 Normal operating mode
- 7.3 Setup mode
- 7.3.1 Parameter
- Parameter 0 (0x00)
- Parameter 6 (0x06)
- Parameter 32 (0x20)
- Parameter 33 (0x21)
- Parameter 34 (0x22)
- Parameter 35 (0x23)
- Parameter 39 (0x27)
- Parameter 80 (0x50)
- Parameter 81 (0x51)
- Parameter 82 (0x52)
- Parameter 83 (0x53)
- Parameter 85 (0x55)
- Parameter 86 (0x56)
- Parameter 97 (0x61)
- Parameter 98 (0x62)
- Parameter 99 (0x63)
- 7.3.1 Parameter
- 7.4 Status diagram as overview
- 7.5 Flow chart
- 7.6 ASCII values for setup
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
- Index
Product Manual - RFID Reader LF40C THR 17
Chapter 4
Safety Instructions
4.1.4 Other symbols
4.2 Obligations
4.2.1 Operating company’s obligations
The safe condition and use of the device is a requirement for the safe operation of
the device. The company operating the device therefore has the obligation to
ensure that the following points are adhered to:
Dispose of packing
material according to
regulations
Recycling
Important
information
Refer to manual
Disconnect from
power supply
The device may only be operated by trained and authorized personnel!
Avoid unsafe and/or dangerous work procedures! If necessary, check
employees' actions!
Only permit personnel to be trained or instructed within the scope of a
general training work on the device under the supervision of an
experienced person!
Personnel must have understood the product manual. Have this confirmed
by signature!
Precisely establish responsibilities according to the various task areas
(operation, installation)!
Operating personnel must be committed to immediately reporting to their
superior any identifiable safety deficiencies which occur!