User's Manual

INSTALLATION 4
27
HF80 Transponder Reader – HSMS, Release 1.3
4.10 DIP-Switches
The DIP switches can be used to change the behavior of some features
of the reader. Parameter 100 enables or disables the functionality of the
DIP-switches.
DIP-switch 1: Communication-Port
OFF: RS232
ON: Ethernet
DIP-switch 2: Test-Mode
OFF: Normal operation mode
ON: Test mode for antenna 1 enabled
DIP-switch 3: not used in this version
DIP-switch 4: Behavior for test mode / polling mode
Test mode:
OFF: Scan UID of all possible tag types
ON: Reading and writing of one page of a ISO15693 tag
Notes:
1. Only DIP-switch 1 is ON by default.
2. If the test mode is active, the test mode has priority.
3. The use of the DIP switches depends on the setting of parameter
‚DIP switches enabled’. All DIP switches are activated by default.