User's Manual

3 PRODUCT DESCRIPTION
18
HF80 Transponder Reader – HSMS, Release 1.3
3.2 Description of Components
Power LED
If the device is connected to a power supply, the LED is illuminated
green and the reader is ready for use.
Status LED
The Status-LED is used as feedback for reading and writing action in
test mode and polling mode. If the reader is in test mode or polling
mode and the read action was successful the red LED is on. In case of
a reading error the LED is off.
RS232 interface (optional)
The device can communicate via the serial interface (9 pin Sub-D
female plug). Baud rates between 1200 Bd and 57600 Bd are possible.
Optional a 10/100BaseT interface is available.
Ethernet interface
The device can communicate via the 10/100 BaseT interface. Optional
a RS232 interface is available. The Device supports Power over
Ethernet (PoE).
DIP-Switches
The 4 DIP switches are used to set some parameters of the reader.
Connector power supply
Plug for the 24 VDC power supply.
Antenna plugs 1 to 5:
The number of the antenna plugs corresponds to the HeadID of the
communication protocol.