User's Manual

PRODUCT DESCRIPTION 3
19
HF5x Transponder Reader (SECS1-Protocol), Release 1.4
3.3 Description
Power LED
If the device is connected to a power supply, the LED is illuminated
green and the reader is ready for use.
Status LED
The status LED is used to check reading or writing. If the reader is in
test mode and the action was OK, the status LED is on. In case of an
error occurs the status LED is off. The action depends on reader
parameter 38.
RS232 interface
The data are passed down serially to the RS232 interface (9 contact
Sub-D female plug) with SECS1 protocol. Baud rates of 300 Bd up to
115.2 kBd are possible.
Fuse
TR5 housing, 500 mA T (low breaking).
HF module
The HF module is the analog part of the device. It triggers the antenna
and transmits the received data to the controller.
Antenna connector 1 to 5:
The number of the antenna connector corresponds to the head ID of the
reader.