User's Manual

SAFETY INSTRUCTIONS 2
11
HF5x Transponder Reader (SECS1-Protocol), Release 1.4
2.3 ESD Instructions
Static electricity can harm electronic components inside the
device. All persons who install or maintain the device must
be trained in ESD protection. ESD protection measures must
be observed when opening the device.
 Before removing or inserting components, disconnect the power
supply.
 To prevent electrostatic damage, static electricity must be
discharged from the body and tools before touching components
inside the device.
 Touch electro sensitive components carefully at their edges only.
2.4 Proper Use
This product was developed for reading and writing transponders only.
Any other use of this device would constitute abuse and would render
the user’s authority to install and operate the device invalid.
All antenna resonant circuit components carry
high voltage!
The installer is responsible for installing the
device to comply with FCC requirements of
human exposure to radio frequency.
To prevent fire, shock hazard, or annoying
interference, use recommended accessories only.
Remove the housing lid carefully to prevent
damage! Do not operate the device when the
housing lid is removed!
Do NOT operate this device without a proper
antenna attached. Proper antennas are antennas
supplied by the manufacturer and listed in section
„Accessories“.
Never locate the antenna so that it is very close to
or touching parts of the body while transmitting.