User's Manual
Table Of Contents
- 1 Identification
- 2 Declaration of Conformity
- 3 General Instructions
- 4 Safety Instructions
- 5 Product Specifications
- 6 Installation
- 7 Operation
- 7.1 Operating Personnel
- 7.2 Theory of Operation
- 7.3 Data Items Dictionary
- 7.4 Attribute (ECID and SVID) Values
- AlarmStatus (Read only)
- ASCII_T1 (ASCII only)
- ASCII_T3 (ASCII only)
- BAUDRATE
- CarrierIDLength
- CarrierIDOffset
- CHECKSUM (ASCII only)
- CID_DISPLAY
- CID_E99_PAD
- CID_ERROR
- CID_JUSTIFY
- CID_MAX_LENGTH
- CID_NP_ASCII
- CID_PAD
- Configuration (Read only)
- DeviceID
- DeviceType (Read only)
- DUAL_SENSOR
- ENABLE_EVENTS
- ENABLE_TIMEOUTS (ASCII only)
- EXTENDEDSSACK
- HardwareRevision- Level
- HeadID
- HeadStatus
- HOST_CONT_PORT1 _LED
- HOSTNAME
- MANTWRITEONLY
- Manufacturer
- MDLN
- ModelNumber
- OperationalStatus
- PARITY
- PIP (Read only)
- PIP_AUTOREAD
- PIP_AUTOREAD_ DATA
- PIP_AUTOREAD_ LENGTH
- PIP_SENSOR_ POLARITY
- RADIO_RETRY
- RDA
- RW_ADJUSTMENT
- RW_REPEATTIME
- SELF_TEST_ RESULT
- SENSOR_TIMEOUT
- SERIALNUM
- SerialNumber
- SIGNALSTRENGTH (Read only)
- SW_PARTNUMBER
- SOFTREV
- SoftwareRevision- Level
- STATUS_ENABLE
- TARGETID
- USETESTDIP
- 7.5 Operation of the SECS Protocol
- 8 Service and Troubleshooting
- 9 Dismantling and Storage
- 10 Transport and Disposal
Brooks Automation
260301 Revision A 85
ATR60LF RFID Reader CAN Bus 8 Service and Troubleshooting
Product Manual 8.5 Error Display with LED
8.5 Error Display with LED
8.5.1 Power LED Does Not Light Up
8.5.2 Read Fail LED Flashes
8.6 Reader Does Not Respond
Check the power supply and the connection cables!
If the LED does not light up, disconnect the device from the
power supply and carefully remove the fuse. Test the fuse. If
it is defective, replace it with a fuse specified by Brooks!
If the above measures do not solve the problem, leave the
reader disconnected and contact Brooks Technical Support!
Reader detected a hardware failure: no valid antenna
adjustment or antenna has broken.
Switch DIP8 to "On" to start an antenna tuning!
If Read fail LED flashes again:
Check if the antenna is located too near to a strong metallic
environment. Relocate the antenna with more distance!
Check if the antenna and the antenna cable are connected
correctly. Use another antenna cable if available!
If these measures do not solve the problem, contact Brooks
Technical Support!
Check if the interface connection cable is undamaged and
correctly connected to both reader and Gateway!
Check the status as indicated by the LED!
If these measures do not solve the problem, contact Brooks
Technical Support!