User's Manual

Brooks Automation
260301 Revision A 45
ATR60LF RFID Reader CAN Bus 7 Operation
Product Manual 7.4 Attribute (ECID and SVID) Values
Current values of status transitions with the corresponding attributes for
CIDRW and Head (if applicable). It has the following values:
1. “PMInformation” - Preventive maintenance information
“NE” = Normal execution
“MR” = Maintenance required
2. “AlarmStatus” - Current CIDRW sub-status of ALARM STATUS
“0” = NO ALARMS
“1” = ALARMS
3. “OperationalStatus” - Current CIDRW sub-status of OPERATIONAL
“IDLE”
“BUSY”
“MANT”
4. “HeadStatus” - The current status
“IDLE”
“BUSY”
“NOOP”
Subsystem ID, 2 bytes (SEMI E99-0200A, referred to as HeadID), e.g. 00,
01, 03, 10, 11, etc.
Identifies where a request for action or data is to be applied. It is zero for
the Gateway (RS485) and non-zero for the associated subsystem
components. It can only be set using the DIP switches on the subsystem.
Where used all stream 18 messages
7.4 Attribute (ECID and SVID) Values
AlarmStatus
(Read only)
Current CIDRW sub-status of ALARM STATUS
“0” = NO ALARMS
“1” = ALARMS
ASCII_T1
(ASCII only)
Inter-byte timeout
2 - 100 * 0.1 s (0.2 - 10 s)
Default: 100 (10 s)
STATUSn Format: 41
TARGETID Format: 41
IMPORTANT
Both 1 and 2 bytes are accepted as TargetID, but a response is always
two bytes.