Br Educ en al ELATION Before Installation IMPORTANT: Please be advised that the provided Cold Water T Valve should be Installed at the fill valve under the foliage tank, and NOT at the cold water supply coming from the wall. NOTE: The Hor Water T Valve will be Installed st the hot water supply under your bathroom sink i you do not have access to the fill valve under the toilet tank, visit us at www broadminded or contact us at $888 542-3385 for further assistance.
BRITT hes al Lite Installation Please read these instructions carefully before installing your Fresh Spa Comfort, Failure to do so could result in flooding, leaking or damage fo the product. 1. Existing toilet seat removal. a. Lift hinge covers and use Flathead or Phillips head screwdriver to remove the mounting bolts. Alternatively, you may need to loosen mounting bolts underneath the seat. b. Remove the toilet seat and set the seat, mounting bolts and hardware aside. 2.
Lo a a Connecting the Hot Water Supply 1. Connect the hot water supply. a. Locate the hot water supply line in your bathroom under your sink/washbasin and turn the water supply valve all the way off. b. Drain the hot water line by turning the sink tap on the hot setting until no more water comes out. Step ic <. Disconnect hot water supply hose to sink from shut off valve. You may have to use a 3%" compatible wrench or a similar tool {not supplied).
PRODUCT Be ALLEY ON Installing the Bidet Attachment 1. Install Adjustable Mounting Brackets into the Bidet Attachment. Place circular mounting brackets into the circular openings of the bidet attachments. 2. Install bidet attachment on toilet. a. Place bidet attachment on the violet so the nozzle is as close to the back of the toilet bowl as it will go. This will vary by toilet. b. Make sure the adjustable brackets line up with the holes in the toilet fixture.
FRONT STALE aT ON Installation 4, Connect hot water tube to bidet attachment {for dual temperature only}. a. Take the hot water tubing pressure connector and remove the pressure cap. b. Slide the pressure cap over the open end of the of hot water flex tubing with the inside threads facing towards the open end. Step 4b ยข. Push the pressure connector into the open end of the of hot water flex tubing with the washer facing out. IMPORTANT.
