Owner’s Manual FS-10/FreshSpa
Table of Contents Product Features. . . . . . . . . . . . . . . . Page 2 Parts List. . . . . . . . . . . . . . . . . . . . . . . . Page 3 Configuration. . . . . . . . . . . . . . . . . . . Page 4 Installation . . . . . . . . . . . . . . . . . . . . . Page 5 Operation . . . . . . . . . . . . . . . . . . . . . . Page 9 Maintenance. . . . . . . . . . . . . . . . . . . . Page 10 Warranty . . . . . .
FreshSpa Feature List: Parts List Hygienic retractable nozzle Self cleaning nozzle feature Ambient temperature bidet wash Nozzle positioning (3 settings) Adjustable water pressure All brass internal valve Bidet attachment with turn dial control Adjustable brackets T-valve connector Bidet hose 2 ea large rubber washer 2 ea small rubber washer All brass 3/8” T-valve High quality braided PVC hose Anti-bacterial ABS material with full body panel Backflow prevention valve No electricity or batteries req
Configuration Installation Check the size of the connection at your water supply shut off valve. It needs to be a 3/8” connector for our T-valve to install between the supply line and the shut off valve. Note: if you have a 1/2” water supply connection at the wall, you will need to purchase the following reducing adapter available online and at many plumbing hardware stores: Reducing Adapter, 1/2” Female NPT X 3/8” Male Compression.
Installation Installation 2) Turn off water supply valve and flush toilet 4) Connect the Bidet Hose to the T-valve a. Connect one end of the bidet hose to the remaining open side of the T-valve. a. Turn off water supply at the wall to stop flow of water. 5) Install Bidet Attachment on Toilet a. Place large rubber washers over the open bolt holes in the toilet fixture. b. Flush toilet and hold down handle to completely empty toilet tank. c. Disconnect water supply hose from water shut off valve.
Installation Operation 6) Connect Bidet Hose to Bidet Attachment a. Connect open end of bidet hose to the brass connection on the bottom side of the bidet attachment. Using the FreshSpa To clean the bidet nozzle, turn the control dial towards the “Nozzle Cleaning” position and water should wash over the nozzle. Step 6a 7) Turn on Water Supply & Check for Leaks a. Open the main water supply valve slowly and check for leaks. b. Wait 5-10 minutes, check again and if there are no leaks continue.
Maintenance Warranty To clean the nozzle, gently pull down on the head of the nozzle, and use a toothbrush or soft cloth and mild detergent (such as dish soap) to clean the nozzles. You may also unscrew the nozzle tip cap for a more thorough cleaning or use a toothpick if any nozzle holes are plugged with hard water buildup. Brondell products are backed by some of the most comprehensive warranties in the industry.
Warranty Contact 4. This warranty gives you specific legal rights. You may have other rights which vary from state to state. Brondell, Inc. PO Box 470085 San Francisco, CA 94147-0085 THIS WRITTEN WARRANTY IS THE ONLY WARRANTY MADE BY BRONDELL. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY SHALL BE THE EXCLUSIVE REMEDY AVAILABLE TO THE PURCHASER.
