Operating instructions

3
Important safety instructions
When using your studio flash equipment, basic safety precautions should always be followed,
including the following:
1. Read and understand all instructions before using.
2. Close supervision is necessary when any appliance is used near children. Do not leave
appliance unattended while in use.
3. Care must be taken as burns can occur from touching hot parts.
4. Do not operate appliance with a damaged cable or if the appliance has been dropped or
damaged – until it has been examined by a qualified service person.
5. Position the cable so that it will not be tripped over, pulled, or contact hot surfaces.
6. If an extension cable is necessary, a cable with a current rating at least equal to that of the
appliance should be used. Cables rated for less amperage than the appliance may
overheat. When using a cable reel, it must be completely unrolled before use to prevent
overheating of the cable.
7. The power pack must be switched off while plugging in or unplugging the lamp base plugs.
8. Always unplug appliance from electrical socket before cleaning and servicing and when in
use. Never jerk cable to pull plug from socket. Grasp plug and pull to disconnect.
9. After use, let appliance as well as the connected lamp bases cool down completely before
putting away.
10. Put away and wind up the cables so that they do not touch hot parts of appliances and
lamps.
11. To reduce the risk of electric shock, do not immerse this appliance in water or other
liquids.
12. To reduce the risk of electric shock, do not disassemble this appliance, but take it to a
qualified service person when service or repair work is required. Incorrect reassembly can
cause electric shock when the appliance is used subsequently.
13. The use of an accessory attachment not recommended by the manufacturer may cause a
risk of fire, electric shock, or injury to persons.
14. Connect this appliance to an earthed socket.